Defocus curve offers comprehensible information about what is the mean behavior of a multifocal procedure. However, a non-optimal analysis of the obtained data can lead to misinterpretation of the results. In this article, we are going to cover two problems in the statistical analysis of defocus curves.

Optimal Manifest Refraction considering the object at infinite and the correction of the vergence distance at which the test is presented for conducting the defocus curve are two very important factors to obtain reliable results.^{1} For example, if we measure the refraction at 4 m, we have to add -0.25 D to obtain the manifest refraction at infinity and if we conduct later the defocus curve at 2 m we have to add +0.50 D to the manifest refraction to obtain the corrected distance defocus curve. Users that do not follow this procedure can obtain a considerable number of shifted defocus curves generally around ± 0.50 D. Furthermore, despite following this procedure, a shift can also appear in some cases. Averaging shifted defocus curves can result in an underestimation of the best visual performance locations and an overestimation at worse locations.

Figure 1A shows the average of a set of measurements for which the highest peak was obtained at the 0 D location, whereas Figure 1B shows the average of defocus curves shifted. Figure 1C shows the result when optimum defocus curves and shifted defocus curves are averaged obtaining a smoother defocus curve. This kind of smooth defocus curve can be seen in studies on which the defocus curve was obtained without manifest refraction and offers an unreliable result that can be wrongly interpreted as a mean Extended Depth of Focus behavior of the Multifocal Intraocular Lens.^{2} This is the reason why defocus curves should be always obtained with manifest refraction and correcting vergence produced by the presentation distance of the test. To avoid averaging shifted defocus curves we developed an algorithm for the Refractive Analysis Toolbox (v.1.0.3) that: (1) moves the highest peak to the 0 D location or in other words correct the peak before averaging and (2) interpolates the missing data because after correcting the defocus shift some missing data can appear at the extremes of defocus curve. Figure 1D shows that after applying this correction we can average all the data obtaining a similar defocus curve that the obtained in the cases of optimum measured defocus curves (Figure 1A).

Effective addition (EA) of a Multifocal Intraocular Lens can vary depending on its dioptric power, the corneal power (Km), and the effective lens position (ELP).^{3} This means that the same MIOL implanted in eyes with higher ELP or higher Km can result in lower Adds than in eyes with lower ELP or lower Km.^{4} This can be shown in the defocus curve measured with the MLA with peaks at different defocus locations.^{5} Figure 2 shows a set of averaged measurements with different Adds of 2.5 D (Fig 2A) and 3.0 D (Fig 2B) for the same MIOL. After averaging DC with different additions we can see that misinterpretation of the near vision maximum peak locations can be obtained.

Data processing of defocus curves can be improved by means of correcting shifted defocus curves and stratifying the datasets depending on the effective addition obtained with the Multifocal Lens Analyzer. For conducting this advanced analysis we added two functions to the Refractive Analysis Toolbox (v1.0.3):

- correctDC: corrects the defocus curve shift and computes the addition.
- allPlotDC: plots the mean defocus curve of a dataset and computes other statistical indices of centrality, variation and areas under the curve.
- sinPlotDC: plots a set of single defocus curves and computes the area under the defocus curve of each one.

References:

- Simpson MJ, Charman WN. The effect of testing distance on intraocular lens power calculation.
*J Refract Surg*. 2014;31(11):726. - Escandón-García S, Ribeiro FJ, McAlinden C, Queirós A, González-Méijome JM. Through-focus vision performance and light disturbances of 3 new intraocular lenses for presbyopia correction.
*J Ophthalmol*. 2018;2018. - McKee HD, Jhanji V. Theoretical effect of lens position and corneal curvature on the near focal point of multifocal intraocular lenses.
*J Refract Surg*. 2016;32(1):64-66. - Savini G, Hoffer KJ, Lombardo M, Serrao S, Schiano-Lomoriello D, Ducoli P. Influence of the effective lens position, as predicted by axial length and keratometry, on the near add power of multifocal intraocular lenses.
*J Cataract Refract Surg*. 2016;42(1):44-49. - Fernández J, Rodríguez-Vallejo M, Martínez J, Tauste A, Piñero DP. Biometric Factors Associated with the Visual Performance of a High Addition Multifocal Intraocular Lens.
*Curr Eye Res*. May 2018:1-8.

Join Our Facebook Group

Access to our Facebook Group to keep you up to date with the latest news or to get support

Terms & Conditions

Review the Terms & Conditions before to use the App

Review Privacy Policy of this website